7
MICROWAVE SENSOR (optional accessory)
The microwave sensor is designed to trigger the alarm when a microwave field registers physical
movement. Two fields are generated, one outside the vehicle to give perimeter protection and one
inside to give interior protection.
Intrusion into the outer perimeter area chirps the siren as a warning, whilst intrusion into the
interior fully sounds the siren. The fields are adjustable for size and should have been set by the
installer at their optimum.
Do not leave people or animals inside the vehicle as any movement will trigger the alarm.
Note: As the microwave produces circular protective fields, some areas of the vehicle may not be
protected.
BOOT BYPASS
– optional (where a vehicle has boot release on the factory remote)
If your factory remote has a boot open facility, the boot circuit and sensors will be bypassed if the
boot is opened by this method. Closing the boot re-arms the boot circuit and the sensors after a 10
second delay.
NOTE: The boot is not bypassed if opened by any other method.
INTRUSION ALERT
If the alarm was triggered whilst you were away from the vehicle, the siren will chirps 4 times
upon unlocking (disarming). Refer to the ‘LED flash codes’ to show how the alarm was triggered.
BATTERY BACK-UP SIREN
Vehicle battery disconnection will cause the battery back-up siren to sound. The siren can be
turned off with the special keys provided. Turning off the siren does not deactivate the alarm or
immobiliser.
The siren is mounted under the bonnet and should be situated in a place to protect it from heat and
water damage. Driving through deep water or puddles may cause water splashes, so caution is
advised.
If washing the engine bay, cover the siren with a plastic bag to prevent water damage.
Heat or water damage is not covered by the product warranty.
