30
VFF Vent Free Fireplace System
Monessen • VFF 32/36 Owner Manual • 20308184 • Rev M • 1/22
LG1071
Mon SC24R logs 10 11
Top Front
Left Log #11
Top Front
Right Log #10
LG1072
Mon SC24R log 12
Log #12 (SC2430EK
Enhancement Kit)
LG1073
Mon SC24R log 13
Log #13
(SC2430EK
Enhancement Kit)
10. Place top front right log (#10) onto mid right log (#6)
by placing notch on bottom of log onto locating block
on log #6. Rest bottom end of log onto grate bar. 57.
11. Place top front left log (#11) onto mid left log (#8) by
placing notch on bottom of log onto locating block on
log #8. Rest bottom end of log onto grate bar. 7
12. Place log #12 onto mid left log (#8) and mid rear log
(#7) by placing notch on bottom of log onto locating
LG1070
Mon SC24R logs 8 9
Center Log #9
Mid Left Log #8
Figure 56
block on log #8. Rest right end of log onto top of log
#7. 8
13. Place log #13 onto log #12 and top front right log (#10)
by placing notch on bottom of log onto locating block
on log #12. Rest bottom of log onto log #10 and center
log (#9). 9
GLASS ONLY PLACEMENT
NOTE:
Two (2) bags of glass are supplied with the VFF32
fireplace and three (3) are supplied with the VFF36 fire
-
place. All of the supplied bags may be used to cover the
entire floor and burner. We advise against using additional
glass as too much can cut off the proper amount of air the
burner needs to operate cleanly. This may cause sooting.
1. Spread glass evenly in one layer over the entire floor
and burner. Be sure to use a single layer only over the
ported area so as not to impinge the flame.
2. Turn burner on and adjust glass over ported areas to
achieve an even, clean flame.
LOG AND MEDIA PLACEMENT
Figure 57
Figure 58
Figure 59
Figure 60
