Monessen • Glow Getter Owner’s /Installation Manual • 4606-900 Rev. A • 8/17
22
4. Hold log #3 in your left hand with the flat surface
down. Place log #3 by matching the two notches on
the bottom of the log with the grate bar on the left and
the pointed end of log #1. See Figure 5.13.
3
Figure 5.13 - Log #3 Placement
5. Hold log #4 with the pointed end toward the right.
Place log #4 by positioning the pin locator hole on the
bottom of the log over the rear left pin on the burner
assembly toward the back and resting the left end of
the log over log #3. Make sure that the flat surface on
the back of the log rest against the rear bend on the
burner assembly. See Figure 5.14.
4
Figure 5.14 - Log #4 Placement
6. Hold log #5 with wide end away from you. Place log
#5 by positioning it over the notch on log #1 and by
sliding the wide end toward the back. When in place,
the left rear of log #5 should come in contact with log
#4 and the left side of the slot on log #1. It should
match with log #4. See Figure 5.15.
5
Figure 5.15 - Log #5 Placement
7. Hold log #6 with the flat end toward the bottom. Place
log #6 by positioning the two pin locator holes on the
bottom of the log over the two pins on log #4 and log
#5. See Figure 5.16.
6
Figure 5.16 - Log #6 Placement
8. Hold log #7 with the flat end toward the back. Place
log #7 by resting it behind log #2 and in front of the
rear bend on the back, rotate clockwise to contact the
back surface of log #7 to the metal bent upward on
the burner assembly. The branch on log #7 should
rest on log #5. See Figure 5.17.
7
Figure 5.17 - Log #7 Placement
9. Hold log #8 with the wider end to the left. Place it
against the first tine on the grate on the right and
rest the pointed end over log #2. See Figure 5.18.
8
Figure 5.18 - Log #8 Log Placement
2
Figure 5.12 - Log #2 Placement