16
Figure 11: Securing Heater to Floor of Fireplace/Firebox
WA
RNING
PLACING and SECURING APPLIANCE
You must secure the gas log heater to the fireplace floor. If not, the entire unit
may move when you adjust the controls. Movement of unit may cause shifting
of the gas logs which leads to sooting and improper burning. Grate move-
ment could cause a gas leak.
Special care is required if you are installing the unit into a sunken fireplace.
You must raise the fireplace floor to allow access to gas log controls. This will
insure adequate air flow and guard against sooting. Raise the fireplace floor
using noncombustible materials.
Assembly procedure:
1. Center the gas log unit in the fireplace or firebox. Make certain the front feet of the grate sit
inside the front edge of the fireplace or firebox.
2. Anchor hole are provided in the front plate of the grate frame. After centering the grate correctly,
mark the hole positions on the fireplace/firebox floor. Drill two (2) 5/32" diameter holes ap-
proximately 1 1/2" deep.
3. Anchor the grate to the fireplace/firebox floor using the screws provided. Refer to Figure 11.
Proper installation of the grate is essential to prevent any movement of the gas logs and controls
during operation.
Summary of Contents for DLY18
Page 31: ...31...
