22
14D9999
14D9999
23
���
���
�
���
��
���
���
Velcro Pads
Remote Receiver
Figure 20 - Installing Remote Receiver
A. COMPLETE MILLIVOLT SYSTEM CHECK
(“A” Reading - Thermostat contacts CLOSED - Control Knob “ON” - Main burner should be come
ON)
a. If the reading is more than 100 milli-volts and the automatic valve still does not come on, replace the control.
b. If the closed circuit reading (“A” reading) is less than 175 millivolts, determine cause for low reading, proceed to
Section B below.
B. Thermopile Output Reading Check
(“B” Reading - Thermostat contacts OPEN - Main burner OFF)
1. Check gas pressure to the unit. If gas pressure is within minimum and maximum on data plate, then check pilot
voltage, 500 millivolts minimum. If the minimum milli-volt reading is not obtainable, replace pilot.
CONNECT
CHECK TO METER THERMOSTAT METER
TEST TEST LEADS TO CONTACTS READING
TERMINALS SHOULD BE
A COMPLETE 2 & 3 CLOSED CLOSED
SYSTEM
B THERMOPILE 1 & 2 OPEN OPEN
OUTPUT
CONNECTING REMOTE RECEIVER
1. Plug in the remote connector to the remote receiver wire.
2. Connect the
1
/
4
female connector to the valve (TPTH and TH terminal).
See Figure 19, page 21.
3. Remove the hearthmount coverplate on the remote receiver. (Battery pack
must be temporarily removed prior to removing the cover plate). Stick
velcro pads with self-adhesive backing to top of remote receiver and to
the underside of the unit.
See Figure 20.
4. Attach remote receiver with velcro pads.
NOTE: Heat reduces battery life. You can protect the receiver
and extend battery life by mounting the receiver in a wall
or other location outside the fireplace.
CHECKING SYSTEM OPERATION
The milli-volt system and individual
components may be checked with a mil-
livolt meter having a 0-1000 mV range.
Conduct each check shown in chart below
by connection meter test leads to terminals
as indicated.
ELECTRICAL WIRING (MILLI-VOLT)