12
14D9999
14D9999
13
HEAT RESISTANT REQUIREMENTS FOR SAFE INSTALLATION WITH WOODEN MANTEL,
MATERIAL SHELF OR OTHER COMBUSTIBLE PROJECTION
MEASUREMENT
DLX18 DLX24 AND DLX28
12" or more Hood not required. Observe profiles (side Hood not required. Observe profile (side
elevations) shown in
Figure 7, page14.
elevations) shown in
Figure 9, page 15.
8" to less than 12" Install hood and observe profiles shown Install hood and observe profiles shown
in
Figure 8, page 14
;
OR
extend heat in
Figure 8, page 14
;
OR
extend heat
resistant material to at least 12" and observe resistant material to at least 12" and observe
profiles shown in
Figure 7, page 14.
profiles shown in
Figure 9, page 15.
Less than 8" Extend heat resistant material to at least Extend heat resistant material to at least
8", install hood and observe profiles shown 8", install hood and observe profiles shown
in
Figure 8, page 14
;
OR
extend heat in
Figure 8, page 14
;
OR
extend heat
resistant material to at least 12" and observe resistant material to at least 12" and observe
profiles shown in
Figure 7, page 14
. profiles shown in
Figure 9, page 15
.
CLEARANCES
AND
HEIGHT REQUIRMENTS
Heat resistant material (minimum requirements) with wooden mantel or other combustible projection:
To install the heater with a wooden mantel, shelf or other combustible projection above, first measure the heat resistant mate-
rial shown in
Figure 6
then
see Table B.
Figure 6 - Measuring Heat Resistant Material for Mantel
TABLE B - Heat Resistant Material Heights and Mantel Location