Monessen Hearth Direct Vent BLDV400, Installation And Operating Instructions Manual

Page: 47 / 68

74D0009 47
FINAL INSTALLATION
Figure 62 - Rock wool placement
ROCK WOOL PLACEMENT
1. Place rock wool on burner to provide glowing
embers. For best results, pull the rock wool apart
into pieces the size of a dime or smaller.
2. Distribute one layer of rock wool to cover the
burner. Figure 61
3. Place the logs on the burner. See Log Placement
below. Light unit and after 15 minutes, check
burner flame and glow. See Burner Flame , page
49.
If the flame is blue and only in the center, turn off unit
and let cool. After unit cools, remove logs. If the back
holes are clear, add more rock wool to the center of
the burner. Replace logs and check flame again. Save
left over rock wool to refresh when cleaning later. Too
much rock wool can disturb the flame and cause soot-
ing on the glass or logs.
Figure 61 - Placement of Rock Wool on Burner
Cover with
Rock Wool
Do not use the entire bag of rock wool
to cover the burner. This could cause
the flame to burn poorly and may lead
to sooting.
W
ARNING
Burner
LOG PLACEMENT
1. Place the rear log (#1) in place by sliding it over
the rear pins on the right and the left.
2. Place the right front log (#3) over the burner and
grate by matching the hole on the bottom of the log
with the pin on the burner. Also match the cut-out
on the bottom of the log with the bars on the grate.
NOTE: When this log is in place pull towards the
front.
3. Place the left front log (#5) over the burner and
grate by matching the holes on the bottom of the
log with the pin on the burner. Also match the
cut-out on the bottom of the log with bars on the
grate. NOTE: When this log is in place the branch
on this log will lay over the rear log on the left. Pull
log forward.
4. Place the right upper log (#2) at an angle toward
the burner by matching the rectangular notch on
the bottom of this log with the rectangular protru-
sion on the right front log (#3). The burned side of
this log will point toward the burner.
HEARTH BRICK PLACEMENT
Place the hearth brick centered in front of burner and slide back until it hits the stops on the right and left of
burner.