Moneris smartselect, Operating Manual

Page: 116 / 198

Private Label Transactions
106 SmartSELECT Merchant Operating Manual v 2.0
E.1: Configuration
If the Private Label card is processed by the Moneris Host, you must configure a
Third Party card (see section
E.1.2: Third Party Card ) and use Host 0.
If the Private Label card is processed by another host, you must first configure a
Third Party Host (see section
E.1.1: Third Party Host ) then configure the Third
Party Card and use that Host you’ve configured.
E.1.1: Third Party Host
Use this transaction to set up communication parameters for processing one or
more Private Label cards to a Third Party Host.
A maximum of nine Third Party hosts (numbers 1 - 9) can be set up.
To set up a Third Party Host
From the Idle screen:
1. Press
Menu
. The
Financial Transactions
menu appears.
2. Press
Config
. The
Terminal Configuration
menu appears.
3. Scroll down and select
Third Party Host
. The
Select Host Number
prompt
appears with nine options.
4. Select a
Host #
list item with a status of
Empty
. (Numbers that are currently in
use display a status of
Active
.) The
Third Party Host Setup Host #_
menu
appears.
5. Select
Host Type
. The
Host Type?
prompt appears.
6. Select the host type you will be using. The
Third Party Host Setup Host #_
menu reappears.
• If you selected
SNS
and are using the SmartSELECT in a hotel or
rental agency, you will need to set the Pre-Auth Type.
• If you selected
Visa1
, you will only be able to perform Purchase Only
Authorizations for Third Party Cards assigned to this Third Party
Host.
7. Select
Merchant ID
. The
Enter Merchant ID
prompt appears with an alphanu-
meric keypad.
8. Key in the Merchant ID provided by the Third Party Card provider (min. 1,
max. 20 characters) and press
Enter
. The
Third Party Host Setup Host #_
menu reappears.
9. Select
Communications Type
. The
Communications Type?
prompt appears.
One or two of the options may be greyed out, depending on how your Moneris
Host connection is configured.
10. Select the communication type the terminal will use to communicate with the
Third Party Host. The default is Dial.
• If you pressed
Dial
, the
Third Party Host Setup Host #_
menu reappears
with
Primary Phone Number
enabled.
a. Select
Primary Phone Number
. The
Primary Phone Number
prompt
appears with a numeric keypad.
b. Key in the Primary Phone Number (min. 7, max. 16 digits) and press
Enter
. The
Third Party Host Setup Host #_
menu reappears.