RC6 novo
14
Change
screen
Via the display, you can perform manual training with full precision and performance!
With Monark novo Display Unit, you can control the bike via the touch screen. The display shows the current
rpm, time, power and pulse (if any heart rate monitor is used).
You can also set up target based training regarding distance, time and calories. If you want to do fitness tests,
etc., you can download Monark test software to your PC from our website, www.monarkexercise.se, and then
connect your PC to Monark novo control unit on your bike.
Start training
The display will start automatically after you have
turned on the power to the bike.
Then the display shows the Start view. Now if you
want to start, press the "Start" button, the display
will show normal mode and the time starts counting.
If autostart is enabled, the time starts count ten
seconds after you have started to pedalling, without
you have to press "Start". Autostart is set in "Settings
general".
This is "Normal mode" that can be displayed in
two versions, complete and simple. You can switch
between them by pressing the arrow keys (change
screen) in the middle of the short sides on the display.
If you want to change the type of workload and
the unit, press the icon for the current selection, see
section "Workload control".
Unit
Time
Auto-
scaling
Target
bar
Menu
Current
heart rate
Pause
Decrease
workload
Increase
workload
Fig: Start view
Menu
Increase
workload
Decrease
workload
Unit
Workload
Pause
Time
Change
screen
Change
screen
Start
Menu
Monark novo Display Unit
NOTE!
To change workload the rpm has to be at least 30.
If rpm is lower, the value is displayed in red. It returns
automatically to normal view when rpm is more than
30.
Fig: Normal mode, complete
Fig: Normal mode, simple
Current
rpm
Workload
Summary of Contents for novo
Page 1: ...MANUAL RC6 novo EN...
Page 2: ......
