Monark 927 E Cardio Care, Manual

Page: 12 / 28

ENGLISH
12 MONARK 927 E
1
2
3
4
5
6
DISPLAY
NOTE!
Do not expose the electronic
display to direct sunlight or
extremely high temperatures. Do
not use solvents when cleaning,
only a dry cloth.
Fig:
Electronic display.
1) Upper display
2) Lower display
3) MODE button
4) (+) button
5) (-) button
6) RESET button
UPPER DISPLAY
Press any button or start pedalling to start up the display.
Then the display is activated and all measured values are
displayed. The timing starts when you start pedalling and
stopping when you stop pedalling. Time is displayed in
full minutes.
The upper display shows Speed, Distance, Time and
Heart Rate.
At heart rate values, a "P" is displayed if the display has
not received any pulse signal from a chest belt. A suitable
chest belt is available as an accessory. More information
about the pulse function in section "Heart rate".
Reset data (RESET)
Press the RESET button to reset the distance and time in
the upper display window. An automatic reset is performed
each time the display is switched off automatically.
Shutdown
After two minutes, the display turns off automatically if
it does not detect any speed or pulse signal. In automatic
shutdown, all values are reset to zero.
LOWER DISPLAY
The count down function in the lower display window
can be set in time or distance - minutes or kilometres /
miles. Press the MODE button to activate and the display
starts flashing. While the display flashing press MODE
again and it shifts between the time and distance function.
As long as it is flashing, the function and value can be
changed or set. Use the (+) or (-) button to increase or
decrease the value. The flashing continues for 15 seconds
after the last press. To activate the function again, press
the MODE button. When the pedalling starts, the
countdown starts in the display. At zero, a tone is heard
indicating that the set time or distance has been reached.
The calorie consumption is shown in the lower display
window, but only if you use chest belt. Press the MODE
button to switch the display mode between time, distance
and kcal.
Change units
To set the display in km or miles, press the MODE button
until "km" flashes. Press the (+) or (-) button to change
to miles.
NOTE!
In order for KCAL to appear in the
display, the chest belt must be
used.