Monark 915E, Instruction Manual

Page: 14 / 18

Fig. 14 Fig. 15
12
REPLACEMENT of SENSOR
FOR ELECTRONIC METER
Remov ethe left chain cover as
described on page ??.
Take it apart at the cable connectors.
Loosen and remove the sensor screws.
Replace the sensor and assemble again
accordin to the above in reverse order.
.
REPLACEMENT OF THE FREEWHEEL SPROCKET
Remove left and right frame cover. For more info see ”REPLACEMENT OF BRAKE BELT”.
Dismantle the chain as described on page 10.
Loosen the axle nuts and remove the flywheel. Remove the axle nut, washer, chain adjuster and spacer
on the freewheel sprocket side. Place the special remover (part No. 9100-14) in the adapter and place
the spacer and axle nut outside. See fig 14.
NOTE: Do not tighten the axle nut completely. It must be possible to loosen the adapter-sprocket half a
turn.
Replace sprocket-adapter and assemble the new parts in reverse order according to the above.
LUBRICATION SPROCKET
The sprocket should be lubricated with a few drops of oil once a year. Incline the cycle somewhat to
make it easier for the oil to reach the bearing. See fig 15.