9
2.0 INSTALLATION AND SETUP
2.1 UNPACKING
2.1.1 Initial Inspection
Exercise care when unpacking the instrument from the shipping carton. The instrument is
packed in a
custom cardboard box
to prevent damage during normal transit. If damage to
the shipping carton is evident, ask the carrier’s representative to be present when the
instrument is unpacked.
2.1.2 Unpacking Procedure
To unpack your Recorder, first remove the cardboard retainer and instrument from the
shipping carton.
Check the box for the following contents - The Recorder, two locking
bars, two 6-32 x ½" screws, AC power supply wall unit (unless the unit is the isolated DC
model) and this manual.
2.1.3 Detected Damage
Remove the instrument from the plastic bag and check for damage if any. Also check that
the unit is as ordered.
If damage is detected after unpacking the instrument, i
mmediately
report any damage to the shipping agent and
re-pack the instrument for return it to the
factory as described in the following section.
2.1.4 Equipment Return
Before returning a damaged or malfunctioning instrument to the factory for repair, contact
the sales organization from which you purchased the instrument. A Return Merchandise
Authorization (RMA) number must be obtained from the factory before returning an
instrument for any reason.
2.1.5 Storage
For prolonged storage before installation, re-pack the Recorder in the shipping container
and store in a cool, dry area. We do not recommend storage of the Recorder for more
than one year. If longer storage time is required, contact the factory for additional storage
information.
2.2 INSTALLATION
The instrument is intended to operate in the following environment:
Indoor Use Only
Installation Category II
per IEC 664
Pollution Degree Level II
per IEC61010-1
Altitude
up to 2,000 m
Temperature
-10 °C to 50 °C operating per IEC61010-1
Humidity
Maximum relative humidity 80% for temperatures up to
31 °C decreasing linearly to 50% relative humidity at 40 °C
Recorder Power
9.0 +0.5V dc @ 4.5VA (unless indicated otherwise on the unit)
AC Mains Supply (External adapter)
100 - 240 Vac ~ 50/60 Hz
NOTE:
The recorder is designed to be panel mounted and as such should be considered as
permanently connected. Disconnection from the supply must be possible via a customer
supplied switch or circuit breaker. This disconnection device must be included in the panel
Summary of Contents for Data Chart 1250
Page 1: ......
