16
English
4 Operation
The operating modes and the setting functions
are selected via a menu by means of the but-
tons MENU, ENTER, UP and DOWN . Figure 13
on pages 26 and 27 shows the selection of the
modes and functions via the menu and the indi-
cations on the display .
4.1 Independent operation
4.1.1 Colour spotlight and stroboscope
In this mode, the spotlight constantly radiates
light of an adjustable colour . In addition, the stro-
boscope function is available .
1) Press the button MENU repeatedly until the
display indicates
.
2) Press the button ENTER . The display now in-
dicates , , , , , or
and a number .
= brightness of red
(0 – 255)
= brightness of green (0 – 255)
= brightness of blue (0 – 255)
= brightness of white (0 – 255)
= brightness of amber (0 – 255)
= brightness of UV
(0 – 255)
= flash rate (0 – 20) of the stroboscope
3) Use the button ENTER to select the seven set-
ting options one after the other, and use the
button UP or DOWN to set the brightness or
flash rate .
Hint:
Setting the brightness of the colours will not only
change their brightness but also the shade of colour
in case the colours are mixed . Therefore, first set the
colour which is to dominate to the desired brightness
and then add the other colours . If the intended colour
mixture is a shade of white, first set the brightness of
the colour green because it appears as the brightest
colour to the human eye . Then add red to result in
yellow and finally add blue to result in white .
Note:
Do not exit the menu item for a colour or the
flash rate with the button MENU before switching off the
spotlight . If you do, the spotlight will remain dark when
you switch it on again .
4.1.2 Different shades of white
Storing 11 shades of colour
In this mode, the spotlight radiates white light .
11 different shades of white are stored which,
however, can be changed . For each shade of
white, the colours red, green, blue, white, amber
and UV can be set to a different brightness so that
this mode can also be used to store 11 individual
shades of colour .
1) Press the button MENU repeatedly until the
display indicates
.
2) Press the button ENTER . The display now
indicates one of the 11 storage locations
(
…
) and the spotlight radiates
the corresponding shade of white .
3) Press the button UP or DOWN to select the
shade of white desired or the storage locations
whose settings are to be changed .
4) To change a setting, press ENTER after you
have selected a storage location . The display
now indicates , , , , or and a num-
ber (0 – 255) .
= brightness of red
= brightness of green
= brightness of blue
= brightness of white
= brightness of amber
= brightness of UV
5) Use the button ENTER to select the colours
one after the other, and use the button UP or
DOWN to set their brightness .
6) To select another shade of white or to change
the settings of another storage location, press
the button MENU so that the number of the
storage location is shown again . Then repeat
steps 3 – 5 .
Note:
If the spotlight is switched off and on again in this
mode, the spotlight will remain dark and the shade of
white desired or the individual shade of colour will have
to be selected again .
4.1.3 Music control
The spotlight is equipped with a microphone to
support music-controlled colour changes and a
music-controlled stroboscope .
1) Press the button MENU repeatedly until the
display indicates
.
2) Press the button ENTER . The display indicates
the mode most recently selected:
= music-controlled colour change
= music-controlled stroboscope
3) Use the button UP or DOWN to select the
mode desired .
Note:
Do not exit the menu item
or
via the
button MENU if the spotlight is to operate in a music-con-
trolled mode after switch-off and switch-on .
