15
English
3 Setting the Spotlight
into Operation
3.1 Installation
•
Always position the spotlight in such a way to
ensure sufficient air circulation during operation .
Never cover the cooling fins of the housing .
•
Always keep a minimum distance of 50 cm to
the illuminated object .
WARNING
When the spotlight is installed at
a place where people may walk or
sit under it, additionally secure it,
e . g . via a safety rope . Guide the
safety rope through the eyebolt
on the rear of the spotlight and fasten it in such
a way that the maximum falling distance of the
spotlight will not exceed 20 cm .
1 . Install the spotlight via its mounting brackets,
e . g . with a stable mounting screw or a support
for lighting units (C hook) on a cross bar .
To align the spotlight, release the two lock-
ing screws of the mounting brackets . Adjust
the desired inclination of the spotlight and
fasten the screws .
2 . Alternatively, set up the spotlight on its own:
Fold out the mounting brackets underneath
the spotlight and use them as a stand . Then
fasten the locking screws .
3.2 Barn doors
To reduce the light beam angle, optional barn
doors are available: PARC-100B . Fasten the barn
doors to the front of the spotlight .
3.3 Power supply
For power supply, the unit is equipped with
Power con connections .
CAUTION!
Never connect or disconnect a Power-
con plug while voltage is applied . Always make
the Powercon connection before making the
mains connection . When disconnecting, always
disconnect the mains connection before discon-
necting the Powercon connection .
1) Connect the blue Powercon plug of the mains
cable supplied to the Powercon jack POWER
IN and turn the plug clockwise until it locks .
(To disconnect the cable from the unit, pull
back the safety latch on the plug, turn the
plug counter-clockwise and remove it from
the jack .) Then connect the mains plug of the
cable to a mains socket (230 V/ 50 Hz) .
2) When the spotlight has been connected to the
mains, it is switched on . The display will show
the menu item most recently selected and go
out after 30 seconds . As soon as a button
(MENU, ENTER UP und DOWN) is pressed, the
display will light up again for 30 seconds .
WARNING
To prevent damage to your eyes,
never look directly into the light
source for any length of time .
Please note that stroboscope effects and fast
changes in lighting may trigger epileptic sei-
zures with photosensitive persons or persons
with epilepsy!
Power supply of
multiple PARC-100 / COL spotlights
If multiple PARC-100 / COL spotlights are used,
the jack POWER OUT of the first spotlight can
be connected to the mains jack POWER IN of
the second spotlight . For this, a mains cable with
Powercon plugs (NAC-3FCB and NAC-3FCA) is
required . Proceed in the same way to connect the
second spotlight to the third spotlight etc . until
all spotlights have been connected in a chain .
Thus, up to 19 spotlights can be interconnected .
The jack POWER OUT can also be used for power
supply of other (light effect) units .
CAUTION!
To reduce the risk of fire caused by
overload, the current load of the cables and the
mains plug must not exceed 10 A .
