MoMi WOODI, User Manual

Page: 14 / 24

14 EN
PRODUCT ASSEMBLY
1. Wooden frame
Take the top (9) and bottom (10) parts of the wooden frame and connect them by aligning both parts
of the frame with the bolt hole. So that the upper part fits into the lower one. Insert a short screw (11)
in the hole and tighten it with a suitable Allen key until you feel resistance.
2. Wooden longer legs
Fit each of the longer legs with the oval holes located from the center of the leg to the convex parts
on each side of the wooden frame. Press the cross nuts (16) into the holes on the sides of the wooden
frame so that you can see the “cross” on the pad from the outside. Align them so that the screw can
enter them. Insert the long screws (12) into the holes on the upper sides of the legs so that they pass
through the anti-slip pads at the same time. Tighten with the smaller Allen key (18) until you feel resi-
stance. If you don’t feel resistance and the screw is turning around, check that the anti-skid washers
are turned properly and the screw is fully threaded through them.