EC/ECM NO: 176403
SAP NO : 187000495
Doc No: 187000495 Doc part: AS
REV-A
MPN/FMT-042 (2016/07/01 REV-00). SHEET No. 3 of 4
If the enclosure is fully loaded with adapters to the adapter plate (rack or cabinet), hold the
Locking Kit base in angle position (approx. 10 degree) as shown in fig 3. to align the positions
of the Locking Kit with enclosure without disturbing setup.
Align the studs to slots and match the holes with the pem nuts, in such a way that it is flush as
shown in Fig 4.
(Fig.3)
(Fig.4)
Ensure the two fixed studs are positioned at slots extreme edge, and all 3 holes are aligned to
pem nut holes as shown fig 5.
(Fig.5)
Fix the screws from the bottom of the Locking Kit base to pem nuts, on enclosure base. Use
the appropriate tool to tighten the screws to the pem nuts, and fully tighten the nuts.
Place the washers and nuts over the base fixed studs, as shown in Fig 6. Use the appropriate
tool, and tighten the nuts.
(Fig.6)
Fixed Stud position
Nuts
Screws
Pem Nut alignment
Washers