EC/ECM NO: 176403
SAP NO : 187000495
Doc No: 187000495 Doc part: AS
REV-A
MPN/FMT-042 (2016/07/01 REV-00). SHEET No. 4 of 4
Once the Locking Kit is ready for use, all connections can be made from front and the inside
of the enclosure.
Port ID label can be affixed to the door plate for port ID identification, as shown in Fig 7.
Use the provided Cam lock to secure the locking kit by rotating 90 degree direction, using
keys.
(Fig.7)
Use the available riveted metal levers (with free rotational movement) rotating 90 degrees
(Clockwise /Counter clockwise) direction to stop/secure the enclosure top cover (as shown
below), when enclosure base is wall mounted, to work on fiber routing, termination and any
other installation work, and bring back the lever to original position by slightly lifting the
enclosure top cover up.
WARNING:
Dust caps should be left intact on all adapters not in use.
Never look into an open adapter as laser light may be present
and is invisible. Serious eye damage is possible.
Metal Lever should be rotated
Clockwise/Counter clockwise,
direction up to the stopper, to
prevent the top cover from sliding
down as shown.
Use 2mm thick washers
M10X20mm (not provided) at the
base, when the Locking Kit is
mounted to the wall along with
enclosure, for better flatness at
base.
locking kit.
Rotate the key counter clockwise
to lock and clockwise to unlock
Top cover
Affix the Port ID label to door plate