64001-7400 Hand Crimp Tool
Doc No. ATS-640017400
Release Date: 05-21-07
UNCONTROLLED
COPY
Page 4 of 9
Revision: A
Revision Date: 05-21-07
TERMINA
L
AGAINST
LOCATOR
TOOL
OPEN
Figure 1
PUSH IN
LOCATOR
CLAMP
Figure 2
TO ADJUST
SLIDE
LOCATOR
LOCATOR
KNOB
LOCATOR
CLAMP DOWN
TERMINAL
IN POSITION
STEP DOWN BUTT SPLICE
Wire Size: 14
– 16 AWG 2.00 – 1.30mm²to
18 - 22 AWG .080-0.35 mm²
Terminal No.
Terminal
Eng No. (REF)
Terminal No.
Mylar Tape
Wire Strip Length
Insulation Diameter
Maximum
In
mm
In
mm
19164-0043
SBA-631
.281
7.14
.230
5.84
STEP DOWN BUTT SPLICE
Wire Size: 10
– 12 AWG 5.00 – 3.30mm² to
14 - 16 AWG 2.00-1.30 mm²
Terminal No.
Terminal
Eng No. (REF)
Terminal No.
Mylar Tape
Wire Strip Length
Insulation Diameter
Maximum
In
mm
In
mm
19164-0077
SCB-646
19164-0582
.281
7.14
.300
7.62
OPERATION
Open the tool by first closing the jaws sufficiently for the ratchet mechanism to release.
Crimping Terminals
1. Push in on the locator clamp to lift and position the nose of terminal under the clamp and
push against the shoulder with the barrel facing up into the color-coded nest. Release the
locator clamp to hold the terminal. See Figure 1.
2. Loosen the locator knob and slide as required until the conductor barrel is centered over
the crimp pocket in the lower jaw as shown in Figure 2. Tighten the locator knob to lock
the locator assembly in position.
3. Partially close the hand tool jaws until the terminal is held snug in place.
