Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0622017500 - ARBOR PRESS - RAST 5.0
Contact us: [email protected] Website: www.integrated-circuit.com
RAST 5.0 Arbor Press
Doc: No: TM-622017500
Release Date: 12-20-00
UNCONTROLLED COPY
Page 12 of 19
Revision: E
Revision Date: 08-14-09
CAUTION: Always disconnect power supply before all maintenance
3.1
Maintenance
(See Chart below for maintenance scheduling,)
Cleaning
The Rast 5.0 Manual Terminator should be cleaned at least once a day with a soft brush to remove dust
and debris.
CAUTION:
Using compressed air to clean the Terminator is not recommended as debris could
become jammed in the tooling and/or come flying out at the operator.
Lubrication
The press needs regular lubrication on a monthly basis. Place a small amount of lubricant with Teflon, such
as Permatex “Superlube”, on the sliding surfaces.
An example of a maintenance chart is shown below. Copy and use this chart to track the maintenance of your
Terminator or use this as a template to create you own schedule or use your company’s standard chart, if
applicable.
Preventive Maintenance Chart
Daily:
Clean. See Section 3.1.
As Required:
Lubricate. See Section 3.1.
CHECK SHEET MONTH YEAR _________
Days of the Week
Week
Daily
Cycles
Daily
Clean
MON TUE WED THU FRI SAT
SUN
Solution
1
2
3
4
Cleaning
Reapply grease
Reapply oil
Soft Brush Industrial
Degreaser
Inspect all tooling, feed
fingers etc. for wear
Replace if signs of
wear.
Schedule should be adjusted up or down depending on usage. Molex recommends that a log of preventive
maintenance be kept with the press.
13 / 20
13 / 20
