Page 3
3. Operation Method (continued)
4) Insert the stripped “wire (12)” from the “terminal number engraving side (4)” until the
“insulation end face (12)” contacts the “locator (8).”
5) Squeeze the tool handle firmly until the ratchet is released (clicks), while holding the wire in
the same position as in below figure.
6) When the ratchet clicks and is released, the handle is automatically opened by the return
spring, and the terminal is crimped.
7) Holding and pulling the “wire (11)” toward the handle gently removes the crimped terminal.
“Note”
Don’t tighten the handle excessively after the ratchet is released, as doing so may
over-crimp the terminal and cause wire breakage of parts damage.
Wire strip length
Insulation crimp height (reference)
Conductor crimp height
Extrude wire length