ImageXpress Micro High Content Imaging System Options User Guide
34
5014166 D
5.
If required, empty the waste bin.
6.
Load an unlidded plate with the live-cell sealing ring on the top.
See
Loading the Sample Plate on page 18
To Configure Fluidics in Meta Imaging Series Administrator
If you change tips, from a 96-well to a 384-well tip, or from a 384-well to
a 96-well tip, you need to configure the fluidics as described in the
following procedure.
1.
Click
Start > Programs > MetaXpress
and then right-click
Meta
Imaging Series Administrator
and select
Run as administrator
to
start the MetaXpress Meta Imaging Series Administrator
software.
2.
Click
Configure Hardware
.
3.
In the
Configure Hardware
dialog, select the correct hardware
configuration, and then click
Configure Devices
.
4.
In the right pane of the
User Settings for hardware configuration
dialog, click
ImageXpress Micro Fluidics
, and then click
Settings
.
Figure 2-2:
ImageXpress Micro Fluidics Settings dialog
5.
In the
ImageXpress Micro Fluidics Settings
dialog, If applicable,
change the tip adapter or the COM port.
ImageXpressOptionsUserGuide.book Page 34 Wednesday, September 9, 2015 3:54 PM
