8
Section 4 – Maintenance and Service
Warning: The maintenance and service procedures included in Sections
4.1 – 4.11 require that all power sources to the Mokon temperature
control system be shut off, isolated and locked out (exceptions noted) and
that the system be completely cooled. Follow all local and national codes
and procedures for working on electrical equipment. Failure to do so could
result in injury or death. Only qualified electrical personnel should install,
maintain, repair, adjust, and operate Mokon temperature control systems.
The instruction manual furnished with the system should be completely
read and understood before system maintenance.
The following hazard warning symbols will be used to denote a specific
hazard associated with a procedure.
Electrical Danger
High Temperature
Surface May Be Hot
High Voltage &
Hot Surface
4.1
Preventative Maintenance
Mokon temperature control systems are designed for a long, trouble free service life under a
variety of conditions, with a minimum of maintenance. Performing the following preventative
procedures will extend the life of your system. Refer to Section 4.1 - 4.11 in the instruction manual
for specific adjustment or service procedures. Refer to the condensed parts list included in Section
8 of the instruction manual for proper replacement parts if required.
The preventative maintenance section is broken into weekly, monthly, and every three months
checks. Associated with each check is a series of corrective procedures that may solve a problem
detected in the check. If the corrective procedures do not resolve a problem detected in the check,
see the trouble shooting guide in Section 7 for a complete list of corrective measures.
