31
Installation with interior adjustment blocks
Caution
In order to protect the system convector against floating when bringing in
cast plasters/flowing screeds, fix the device at the raw floor at the provided
points.
The adjustment blocks included in the scope of delivery are only intended
for levelling purposes! In order to obtain step-on ability, increase the num-
ber of adjustment blocks or support the system convector over the entire
surface
(see also „Step-on ability“).
A traverse mounted to the bottom of the system convector is required additionally in
case of installation with interior adjustment blocks. This will distribute all load forces
to the entire system convector.
¾
Insert the adjustment blocks into the traverse and screw them in until they protrude
a little on the opposite side.
¾
Tear off the protection foil from the adhesive tape. Keep the adhesive surface free
from dust and grease in order to preserve the adhesion.
Install interior adjustment
blocks
Remove protective foil
Installation
*not included in the scope of delivery
¾
Level the system convector to an even height dimension using an Allen key (4
¾
Fix the system convector to the raw floor using the provided fixing points. Use
a dowel* and a sufficiently long 6 mm countersunk head screw* as well as the
provided rosette washers for this.
¾
Position the traverse to the required location and press on firmly. Take care that
it is positioned flushing on the bottom plate between the side parts edges.
Install the traverse
Fixing the system convector, lateral view
Fixing the system convector, front view
Summary of Contents for WLK 180
Page 19: ...19 ENG DEU RUS ITA DAN Notizen ...
Page 39: ...39 ENG DEU RUS ITA DAN Notes ...
Page 59: ...RUS ENG DEU ITA DAN 59 Заметки ...
Page 79: ...79 ITA ENG RUS DEU DAN NOTE ...