Mohlenhoff WLK 180, Manual

Page: 30 / 100

30
ENG
DEU
RUS
ITA
DAN
1 2 3 4
Install and align air spout DN80
Air spout installation
¾
Position the air spout DN80 above the primary air inlet and align flushing. The bent
down edge is provided as installation aid. The installation aid defines the horizontal
position of the air spout DN80; for this, it must flush against the system convector
bottom..
¾
Fix the air spout at the three provided positions using self-tapping screws (3.9 x 9.5
mm). Take care not to tighten the screws excessively.
Hint
It is not necessary to pre-drill the installation holes. The self-tapping screws
can be screwed in e. g. with a cordless screwdriver and an adequate magne-
tic cross-head driver bit using light pressure.
1 Primary air inlet
2 Air spout DN80 3 Self-tapping screw 3.9 x 9.5 mm
4 Installation aid
Installation
Installation of exterior adjustment blocks
Exterior adjustment block with fixing: Fix with screws
Exterior adjustment block with foot: Latch into the trough profile
1
2
1
2
Installation with exterior adjustment blocks
Caution
Permanent damage to the device!
In order to protect the system convector against floating when bringing in
cast plasters/flowing screeds, fix the device at the raw floor at a minimum
of two points using adjustment blocks.
*