-28-
Revision 2/F3506
2 Screws
Two Screws
Two
Screws
6.3.17 OUTER GLASS
6.3.16 MOTOR
1)
Remove fan (refer 6.3.14) and then
remove the wires that go to the motor.
1) Open door
2) Undo two screws securing Turbofan cover
plate to oven, and remove cover plate.
2) Undo the four screws holding the motor
bracket in place (from the outside) and
remove motor assembly.
3) Remove LH screw whilst supporting the
door. Lift bracket and remove door from
oven.
Figure 6.3.23
Screws (4)
3) Remove three screws holding motor to
bracket and remove motor.
4) Replace and re-assemble in reverse
order.
5) Ensure wire connections are correct to the
voltage supply—60 Hz / 50 Hz (fig 6.3.23)
Figure 6.3.24
Three Screws
4) Remove screws securing door handle.
Figure 6.3.26
Figure 6.3.25
LH Screw
5) Remove two screws in top trim and two
screws in bottom trim of door, and remove
trim panels.
Screws
Figure 6.3.27
6) Lift outer glass away from door.
7) To replace, ensure that the two silicone
rubber seals are in place on the left hand
and right hand side of the door frame.
Clean the inside of the glass and refit it,
ensuring that the silicone rubber seals
cover the outer edges of the glass. Refit
the bottom trim.
Figure 6.3.28
60 Hz
Terminal
50 Hz
Terminal
Earth /
Ground
Neutral