Moeller CM4-505-GV1, Hardware And Engineering

Page: 21 / 78

AS-i/PROFIBUS Gateway Operating the AS-i/PROFIBUS Gateway
is
s
u
e
d
a
te
2
2
.6
.2
0
0
1
21
5.6 Setting of the PROFIBUS Station Address
5.6.1 PROFIBUS Station Address
Station addresses from 1 to 99 can be set, when delivered station address 3 is set.
For the relocation, both the “set” button and the “mode” button have to be pushed si-
multaneously for at least 5 seconds until the current bus address is shown on the LCD
display. With every pushing of the “set” button, the station address can now be in-
creased by 1.
Once the desired PROFIBUS station address is shown on the display, it will be stored
non-volatile in the EEPROM by pushing the “mode” button. E.g. the PROFIBUS DP
Mastersimulator DP V1 can be used to chage the AS-i/PROFIBUS gateway's station
address via PROFIBUS.
5.7 Error Messages
The addressing of the AS-i/PROFIBUS gateway as a PROFIBUS slave
can be done locally at the gateway or via PROFIBUS according to the
PROFIBUS standard.
The system displays error codes for error messages that do not point to
faulty assignments on the AS-i circuit. The code numbers are larger
than 50 and are therefore outside the slave address range. These
codes are described in the appendix, chapter 9.