MODSTER M225717, Manual

Page: 31 / 48

F
Manual - Vector SR48 Brushless
www.modster.at 31
1. Power off the ESC.
2. Disconnect the battery in hull.
3. Power off the transmitter.
4. Remove batteries from boat and transmitter.
Notice: Always store the boat without the hatch covered or inner liner sealed. Otherwise
moisture cause mold and mildew to grow in the boat
Always replace the shaft when it is damaged or shows visible wear or injury and property
damage my result. Lubricating the shaft is vital to the life of the drivetrain. The lubricant acts
as a water seal, keeping water from entering the hull through the stuffing box. Lubricate the
shaft, propeller shaft and all moving parts every 2-3 hours of operation. Always replace any
parts that show visibly wear or damage.
CAUTION: Running the boat in salt water is not allowed and will void the warranty. If the boat
has been driven in salt water, clean it with fresh water after each use and lubricate the drive
parts.
Warning: Due to the possibility of corrosion, the use of the RC boat in salt water is at the sole
discretion of the user.
1. Loosen the coupling between the motor
and the shaft.
2. Loosen setscrew from the shaft and remove
the shaft from the back of the boat Tip: Use
paper or cloth to touch the shaft.
3. Remove the drive shaft by sliding it out
of the stuffing box. Wipe lubricant and
material from the shaft. Lubricate the full
length of the shaft assembly up the drive
dog with marine grease.
4. Apply threadlock to the coupling setscrew.
Threadlock will help prevent the shaft from
loosening during usage.
5. Carefully reinstall the drive shaft, ensuring
that there is a 1-2mm gap between the prop
strut and the drive dog to allow for shaft
schrinkage under load.
When you finish
Maintenance