MODSTER M225717, Manual

Page: 32 / 48

F
Manual - Vector SR48 Brushless
32 www.modster.at
1. Align the propeller with the drive dog on the flex
shaft, then install the propeller using the included
locknut.
2. Install the rudder horn to the rudder by two screw.
3. Install the rudder to the rudder holder and fix it by
a bolt as shown in the graphic.
4. Connect the cooling line to the fitting on the top
of the rudder.
5. Ensure the trim tab panel is either perpendicular
or parallel to the bottom of the boat. If its needed
to switch the angle of the panel, tie or release
the screw which is touch the panel to switch the
angle.
Rudder Installation
Before boating:
• Install fully charged batteries in your boat and transmitter.
• Connect the boat battery to ESC.
• Make sure the boat is bound to the transmitter (otherwise, bind the boat to the transmitter)
• Make sure all linkages move freely on the boat.
• Ensure the motor mount is secured to the hull so that the motor stays steady.
• Perform a Control Direction Test with the transmitter.
• Adjust the steering rate on your transmitter as needed.
• Find a safe and open boating area.
• Plan a safe boating route for the water and wind conditions.
After boating:
• Always turn off receivers before turning off transmitters to maintain control of the boat and
to retain binding.
• Disconnect the battery from the receiver and remove the batteries from the boat.
• Fully dry the in- and outside of the boat, including the water cooling and jackets around
the motor and ESC. Remove the hatch and radio box cover storing your boat.
• Repair any damage or wear to the boat.
• Lubricate the shaft.
• Make note of lessons learned from the trimming of your boat, including water and wind
conditions.
• If you use the boat in salt water (at your own risk) please rins with fresh water afterwards.
Tip: The hook and look strips in the boat retain water. To dry them press on them with a dry
cloth.
Check List