FR-W1801
Wynd Instructions
16
5. Hanging the Fan
CAUTION:
Failure to properly install the cotter pin and/or tighten
the set screws could result in the fan loosening and possibly falling.
NOTE:
Make sure all screws are tightened and that wires
are not twisted.
1. Remove screw from hanger ball. Remove hanger ball and cross
pin (Fig. 5).
2. Loosen 2 screws, clevis pin and cotter pin (Fig. 5).
NOTE:
Confirm all connection points on the molex connector are
tight and secure. If any wires are loose, it may cause the fan to not
function. Fig. 4 thread the downrod into the motor housing until you
can reapply the clevis and cotter pins. Tighten the 2 screws.
3. Slip the coupling cover, canopy screw cover (painted side face
down), and canopy (opened side up) onto the downrod. Coupling
cover goes all the way to the bottom. Reinstall the hanger ball
onto the downrod (Fig. 5A).
4. Seat all into the mounting bracket. Rotate until ball drops and
locks into hanger bracket screw (Fig. 5B).
5. Secure the safety cable into the structure beams using the wood
screw, washers, and spring washers provided. Use
D
hardware.
NOTE:
Safety cable is required for all ceiling fan installations in
Canada. Safety cable is required for ceiling fan and light (combo)
installations over 35 lbs. in both flush and downrod models in the
United States.
