FR-W1801
Wynd Instructions
14
4. Assembling the Fan
CAUTION:
Failure to properly install the cotter pin and/or tighten the
set screws could result in the fan loosening and possibly falling.
NOTE:
Screws for adapter plate (Parts Image 6) are preinstalled on
the fan motor assembly on the small ring at the center of the blades.
Remove blue packing ring if present.
1. Remove one screw from the mounting ring on the motor assembly
and loosen the other 2 (Fig. 4).
2. Seat the adapter plate (Parts Image 6) on the center ring and twist
to lock the keyhole cutouts onto the screws previously loosened
(Fig. 4A).
3. Replace the 3rd screw and tighten all 3 until snuggly secured by
hand.
NOTE:
Screws for luminaire module plate (Parts Image 7) are
preinstalled on the adapter plate (Parts Image 6) on the middle ring.
Luminaire module itself comes preinstalled on its mounting plate.
Attach the LED wires to the fan. Connect the Blue from the LED to the
Blue from the fan. Repeat same process for the White wire.
4. Remove one screw from the adapter plate and loosen the other 2.
5. Seat the luminaire module plate on the adapter plate and twist to
lock the keyhole cutouts on the screws previously loosened (Fig. 4B).
6. Replace the 3rd screw and tighten all 3.
7. Install glass shade without over-tightening or install metal light
cover (Fig. 4C).
NOTE:
Add metal light cover if you do not need lighting function or
prefer a different aesthetic.
NOTE:
Do not connect the LED connector wires if you are using the
metal light cover.
NOTE:
Do not overtighten screws or you may strip the screws or
damage the plating.
