14
FH-W1802
9. FINISHING THE INSTALLATION
1. Secure all wire connections with supplied wire ties to assist in fan
installation.
2. Tuck connections neatly into ceiling outlet box.
3. Remove the motor from the hook on the mounting bracket. Slide
the motor up to the mounting bracket and place the key hole on
the motor over the screw on the mounting bracket. Turn motor
until it locks in place at the narrow section of the key holes.
(Fig.
13)
Note: Make sure the receiver sits flat and does not interfere with
the
hook.
4. Align the circular hole on canopy with the remaining hole on the
mounting bracket. Secure by tightening the two screws previously
loosened and the two screws previously removed.
5. Raise up trim ring and line up the 4 tabs with the 4 grooves on the
mounting bracket. Once lined up, slide the trim ring and secure it
to the canopy until snug.
Motor
Trim Ring
Mounting Bracket
Screws
FIGURE 13
