7
2.
Turn on the tap with pressure (0.03
～
0.6MPa
）
Bad installation of quick joint will cause water-leaking, please check:
1.
Whether the flat surface of tap bore is plain or not.
2.
Have the four screws been switched tightly?
3.
The socket must be safely earthed, then connect the
wire.
To ensure your safety, the washer must be earthed.
1.
The washer uses three phase power cord. It should use three
phase sockets during installation, if there
isn’t
any earth socket,
you must ask special technicians for installation.
2.
The ground wire must connect with power socket.
3.
The ground wire of the washer is already installed with the plug.
Don’t
change the plug personally.
4.
The ground wire should never be connected with the gas pipe,
tap water pipe, antenna or lightning rod etc.
5.
The cross-section area of the ground wire is at least 0.75 mm
2
.
6.
The power cord of the washer is connected by Y shape. If it its
soft wire is damaged, you should ask special technician. You are
not allowed to do it by yourselves.
7.
Please use the washing machine with the rated voltage and
current according to rating label.
4.
Lay down the drain hose
1.
Don't fix and seal the outlet of drain hose in the sewer. Or the
air will be prevented from the drain hose and the drain hose will
be clogged or not drained.
2.
Never let the end of the drain
hose immerses in water.
3.
In order to prevent siphoning,
please ensure the end of the
drain hose is fitted minimum
60cm and maximum 100cm
above the ground.
5.
Ensure the clothes meet the washing requirement before
putting them in
Summary of Contents for WT 1121 WAM
Page 1: ...User Manual Book Top Load Washing Machine WT 1121 WAM ...
Page 19: ...11 20 ...
