
USER MANUAL | M1000-M-DA3
USER MANUAL | M1000-M-DA3
As you move the point on the screen, you will hear the
sound adjust. For each point in the Eq curve you can
adjust the left and right Q-factor or you can link the Q-
factor together.
There is also a checkbox for watermarking the related
speakers. This allows you to see exactly where the
cross-over points are for each speaker in your system,
so matching cross-over points becomes a little easier.
Individual Channel Equalization
Each speaker can be equalized or tuned to your own
taste. NB: If the ‘XOVER L/R LINK’ radio button is
selected, the linked speakers of left and right will be
equalized together. We recommend this for initial tuning.
You can always uncheck this radio button to fine tune
individually later.
Go back to the ‘Configuration’ TAB at the top left corner.
Here you will see a flat yellow line across the Parametric
Equalizer towards the bottom of the screen. Take make
adjustments, you just select a point with your mouse,
click and hold, and then drag it to your desired setting.
You can do this up to 1000 points!
FIG 03
CHANNEL EQ
CONNECTED
0.00Hz
Default
Preset 01
12dB
50Hz
100Hz
500Hz
1KHz
10KHz
5KHz
20KHz
6dB
0dB
-6dB
-12dB
-18dB
-24dB
DELETE
CLEAR
FREQ
0.00Hz
0.00Hz
MAG
0.00Hz
0.00dB
CHANNEL GAIN
0.00Hz
0.00dB
Q-FACTOR
0.00H
0.01
0.00Hz
0.01
Q-L/R
CHANNEL
WATERMARK
CONFIGURATION
Channel Equalizer
FRONT LEFT TWEETER
FILTER SETTINGS
0.00Hz
High Pass
0.00Hz
0.00Hz
FILTER TYPE
Lo-P SLOPE
Lo-P Hz
INVERT PHASE
XOVER L/R LINK
TIME ALIGNMENT
0.00Hz
0.00ms
0.00Hz
0.00ms
20
6 dB
0.00Hz
Butterworth
0.00Hz
0.00Hz
FILTER MODEL
HI-P SLOPE
Hi-P Hz
2000
24 dB
FIG 03
1
2
3
4
5
FIGURE 03
You can see in FIG 03
that we have placed
two points in the Eq
curve and that we have
adjust one point at
6136Hz down a little
and adjusted the left
Q factor down to 0.01
and the right Q-factor
is at 0.01. There is
also a slider bar for
channel gain control.
This allows each speaker
output to be set to the
appropriate sound level.
PAGE 10
PAGE 09
Q-FACTOR
CHANNEL GAIN
EQ POINT