MOBISAT
®
TITAN - User Manual v.2.0.3 - www.mobisat.eu - Page 10 of 16
INSTALLING TITAN
▪
TITAN should be installed on surfaces that are NOT covered by metallic
elements
▪
TITAN must be securely attached to the surface or the cables
▪
TITAN cannot be installed onto moveable or overheated parts
▪
The SIM card must be inserted when the connector is unplugged (TITAN is
not powered on)
Position TITAN as shown in the Figure.
The GNSS antenna is under the logo, and should therefore face upwards. It is not advisable to install the device at a point that is
more than ¾ covered with metal surfaces.
Thanks to its IP67 protection, TITAN can also be mounted outside the vehicle. TITAN has 4 holes on the IP67 casing for fastening
with screws (optional). TITAN can be fixed with cable ties or adhesive tape.
OPTIONAL ACCESORIES
CAUTION: Extra accessories such as iButton
®
, door sensors, panic buttons, etc., must be purchased separately.
INSTALLING AN iButton
®
iButtons
®
are unique recognition devices, since each has its very own unique alphanumeric identification code.
TITAN is able to read these devices thanks to its Dallas WIRE connection
®
. iButtons
®
can be used for:
▪
Driver recognition. TITAN is capable of storing up to 50 iButton codes
®
.
In this mode, the vehicle cannot be started with
the ignition key alone; the vehicle can be started if the driver possesses an iButton
®
with a code that is recognized by
the system.
▪
Immobilizer function. In this mode, TITAN prevents the vehicle from being started up until the iButton
®
is connected.
This will prevent the start of the vehicle in the event that an attempt is made to start the vehicle with the ignition key
alone. In this mode, the vehicle is authorized only if an iButton
®
has been connected.
N.B. to use the Immobilizer function, the DOUT2 output (digital output 2) must also be installed to the starter motor, as
indicated on the next page.