CONTINUED 7. REMOVAL OF INDIVIDUAL REMOTES (CHANNELS)
WARNING!
Repeat step 2 to proceed to remove the next remote control. However, if within
20 sec. no programming operation is started, the receiver automatically returns to operating
mode. Return to operating mode can also be performed manually using the
MASTER
. In such
a situation, simultaneously press and hold the
STOP
and
MASTER
buttons until the connected
actuator executes one sequence of noticeable and audible micro movements down / up. In
both cases, the return to operating mode will be through one sequence of micro down / top
moves of the connected actuator.
8. CONNECTING THE ADDITIONAL SWITCH / DRIVER
It is possible to connect an external keyboard connector (without support)
- Fig. 8.1
, bell connector
-
Fig. 8.2,
control via a controller with relay output
- Fig. 8.3.
They must be connected according to the
attached diagram.
Fig. 8.1
L1
N
PE
N
PE
230V~ 50Hz
a
b
L1
N
PE
N
PE
230V~ 50Hz
a
c
b
L1
N
PE
N
PE
230V~ 50Hz
a
b
L1
N
PE
N
PE
230V~ 50Hz
a
c
b
c
7
