MOBILUS C-MR, User Manual

Page: 5 / 16

5. CHANGING THE DIRECTION OF THE ACTUATOR
1. If you press the UP button on the remote control and the armor goes down, change the
direction of rotation of the drive. At the same time, press and hold:
a ) on the remote control COSMO | HM, | HB, | G3+, | WT9, | WT buttons STOP and DOWN
- Fig. 5b ;
b ) on the remote control COSMO | HT, | H24,| H1, | H5, | G, | W1, | W7 buttons DOWN and UP
- Fig. 5c ;
c ) on the remote control COSMO | HCT UP and F3 buttons
- Fig. 5d ;
until the drive executes one sequence of micro down / up moves.
2. Check the UP / DOWN buttons
- Fig. 5e .
Fig. 5
a e
b
c
d
6. C-MR MODULE RESET - FACTORY SETTINGS
WARNING!!! RESTORATION OF FACTORY SETTINGS erases all programmed remotes from the
MOBILUS C-MR module.
1. Enter the PROGRAMMING MODE for the MOBILUS C-MR module -
Fig. 6a
.
2. In the PROGRAMMING MODE, press and hold the programming key above 5 seconds -
Fig.
6b
. All previously loaded remote modules have been removed from the memory module
which confirms one sequence of noticeable and audible micro moves down / up of the
connected actuator.
5