Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
push them down. This function helps to transfer the user in to and out of the chair and to
wash the user.
●
Never leave chair unattended with armrests lifted when there is someone in it.
Tilt adjustment function
●
Seat tilt adjustment function allows you to adjust the angle of seating
position -5 to +25°.
●
It can be activated by depressing the levers located in the rear top part of
the back.
●
After depressing the levers you can move the seat angle up or down.
Adjusting of seating angle increases the comfort of the user and helps to
wash and to move the user into or out of the chair.
●
Never leave patient unattended in the chair with seat tilt adjusted to the
max front or rear tilt position.
Transport recommendations
The “Kakadu” commode and shower chair is not a device designed for frequent transportation. If it is
necessary to transport the chair, we recommend to disassemble it in the way opposite to the
assembly description above. The chair should be packed in a way where it is stable and there is no
risk of sudden and dangerous movements of the transported device.
Accessories – safety belt
It is possible to mount a safety belt on the chair.
It is important that the safety belt has loops at the end
like the Mobilex belt (Item no. 233012).
The loops should be placed at the backrest by lifting the
backrest like at pic. 6
Be aware that the belt is turned the right way before the
backrest is put back into position like in pic. 7
Mounting of 24" rear wheels (extra equipment)
It is possible to replace rear 5” small wheels with 24” big wheels with pushrims for self propelling.
Assembly of this kind of wheels requires also mounting of typical wheelchair brakes. It is all included
in the accessory kit (Item no. 302023) together with fxing bolts, assembly clamps and plates.
Replacement description:
●
Disassemble the 2 rear standard wheels in the way opposite to previous assembly instruction.
●
Fit the 24“ wheels assembly to the rear vertical side-frame tube (as shown on picture 8).
●
There are holes drilled in the tube that allow to adjust the chair to diferent seat heights.
Choose 2 required holes and adjust the assembly plate so it's fxing holes are in line with tube
holes.
●
Insert 2 fxing bolts through all the holes. Apply washer and nut. Tie the fxing bolts, so the
assembly plate is very stable.
●
Repeat above steps for the other side of the chair.
●
Press the quick release button located in the middle of the big wheel. Insert the wheel into the
housing on assembly plate. Release the button (Pic. 9)
●
Always check if the wheels are attached correctly by trying to pull them out.
●
To take away the wheel press the quick release button and pull the wheel out of it's housing.
●
After assembly of big wheels it might be necessary to readjust the height of the front small
wheels as it was described previously. The main bottom frame always has to be in position
parallel to the foor.
●
For the 24” wheels it is necessary to mount regular wheelchairs parking brakes as wheels are
not equipped with their own brakes.
●
The brake assembly consists of mounting clamp, Brake Mechanism and 2 fxing bolts.
●
Insert the sliding profle of the brake in to the smaller cut out of mounting clamp.
Rev. 08.19
Page 5 of 7
UM-302024-25-GB
Pic. 6: Open backrest
Pic. 7: Belt mounted
