Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
wheels assembly tube (as shown on the picture).
●
Adjust the wheels vertical tube to the position, where one of its holes would match one of the
holes in the frame. Thanks to this solution it is possible to set the seat height of the chair in 3
diferent heights (in 2,5 cm steps).
●
When required position is reached insert the fxing bolt through all the holes and tie it with the
nut from the opposite side of the tube. Always adjust all 4 wheels to the same height.
●
Check if all wheels are locked correctly by pulling them upwards. They should not be able to
slide out or shake.
Brakes
●
Now turn the main frame around into it’s correct position so it would stand on the wheels.
●
Before further assembly lock all wheel brakes, in order for the device not to move.
●
To engage the brakes step down with your toes on the pedals attached to the rear part of
each wheel until they are locked. To disengage the brakes pull up the pedals with your toes
until they will unlock.
-
Never leave chair without breaks engaged when there is someone sitting in it
- Always engage brakes when entering or leaving the chair
- Always engage the breaks when you don’t plan to move the chair
Backrest
●
Now slide back frame tubes’ endings in to two assembly holes located in the rear top part of
main frame.
●
Tighten the bolts on both sides of the frame, so the back is stable and rigid.
Headrest
●
Put the vertical bar of the headrest into the clamp located at the top middle of the back.
●
Tighten the bolt located at the clamp when headrest is adjusted to required height, so the
vertical bar won’t move up or down.
Toilet bucket
●
Put the lid on the bucket (pic. 1).
●
Slide it in to the rails located under the seat. You should do it from the back towards the front
of the chair (pic. 2).
●
When bucket is its place cover the middle hole of the seat with the PU cover (pic. 3).
Pic. 1
Pic. 2
Pic. 3
Footrests
●
Now you can attach the footrests.
●
Put the footrest’s top end into the hole located at the top front end of the main frame. The
footrest should be directed outwards at that point.
●
Now turn the footrest in until it will lock in its front position.
●
Repeat the same procedure for the second footrest.
●
To unlock and detach the footrest press the locking lever, turn the footrest outwards and then
pull it up. The above function together with these elevable footplates help to transfer the user
into and out of the chair. It also helps to wash all the parts of the user´s body during the
shower when footrests are swinged away or removed.
●
Never move the chair with footrests detached when there is someone in it. Always put user’s
feet on foot plates when moving the chair.
Armrest
●
Armrests can be easily lifted by pulling them up. To move them back in to low position simply
Rev. 08.19
Page 4 of 7
UM-302024-25-GB
