MobileView 3008, Installation Manual

Page: 20 / 117

Chapter 2: Camera installation
14 MobileView 3012 Series Installation Manual
10. Use the three machine screws with red nylon washers to attach the camera to
the base. Hand tighten the screws until snug.
Figure 10: Remove the cover
Adjusting the lens
Once the camera is mounted, it is adjustable in three dimensions. The camera
module is a ball in a cup.
The ball will rotate in any direction in the cup for view adjustment: up, down, left,
right, clockwise, counter-clockwise, etc. However, large adjustments can create
internal wire tension. Therefore, we recommend positioning the camera as close
as possible to the correct orientation during installation so that you do not need to
make adjustments that rotate the ball more than 45 degrees clockwise or
counter-clockwise.
1. Connect appropriate power and a video monitor to the camera, or connect the
camera to the DVR, to view the image and adjust the angle of view and focus
of the lens to ensure the desired image.
2. Two screws, one on each side of the camera, secure the camera lens cup
and also lock the camera lens ball in place after adjustment. Loosen these
two screws slightly (do not remove the screws) and rotate the camera as
necessary for final view alignment. Tighten the screws when finished with the
adjustment.