MobileView 3008, Installation Manual

Page: 14 / 117

Chapter 2: Camera installation
8 MobileView 3012 Series Installation Manual
System layout
Camera layout and fields of view vary based on several factors including vehicle
seating arrangements, partition walls, door location, and customer guidelines. It
is the responsibility of the installer to ensure that these factors are adequately
considered before installation begins.
Figure 2 below shows a typical, eight-
camera layout generally used on a 40’
transit bus. While most areas of the vehicle are covered when cameras are
located in this manner, this illustration is provided as a guide and not a rule for
actual camera placement. In all new installations, you should obtain customer
acceptance of camera location and fields of view as part of installation planning.
Figure 2: Typical eight-camera setup with fields of view shown
1. Front door camera. Front of the bus over
the driver’s head, looking at the front
passenger entry.
2. Forward-facing camera. Front of the bus,
looking in front of the bus.
3. Front-to-rear camera. Front of the bus,
looking down the center aisle to the back.
4. Rear exit camera. Across from the back
door, looking at the back doorway.
5. Rear-to-front camera. Back of the bus,
looking up the aisle to the front of the bus.
6. SideEye side camera. Exterior of the bus
by the front door, looking toward the back
of the bus.
7. Center-to-rear camera. Between the front
and back door, looking down the center
aisle to the back of the bus.
8. SideEye rear camera. Back of the bus,
looking behind the bus.
Note: Cameras 6 and 8 in Figure 2 above are MobileView SideEye cameras.
Camera 2 is a MobileView forward-facing camera. For installation of these
cameras, see their respective manuals, shown in “References and related
documents
” on page 6.