MANUAL MODE
When the unit is in manual mode the panel LED MAN will be
and the
ON
MAN
will appear on the screen, as shown in the picture below for left side.
When unit is in this mode, blade movement is only controlled by the user. By
pressing the
or by using the joystick.
[UP/DOWN] key
4.2 SETTING VALVE CONTROL MODE
From the panel use the
key to switch between the two modes of control for
[A/M]
the hydraulics valves.
Laser Sensor
+015
MAN AUTO
Laser
ON
Ref = 012
Laser Sensor [mm]
In this mode, the panel automatically brings the blade to the centre position. The
user can temporarily override automatic control at any time by pressing the
[UP/DOWN] key or by using the joystick.
Automatic control returns upon release of the buttons or joystick handle.
WARNING:
Extreme care should be exercised when switching the
to Auto
DUO
2
for the first time in an unfamiliar setup. The mounting of the sensors might be
such that, in attempting to achieve center, the blade forcefully digs into the
ground; or the default hydraulic settings might cause the blade to oscillate and/or
considerably overshoot the center position. The user should be on guard to
immediately switch to Manual hydraulic control or switch the unit off.
AUTO MODE
When unit is in automatic mode, the panel LED AUTO will be on and AUTO will
appear on the screen as shown in the picture for right side.
Laser Sensor
+015
MAN AUTO
Laser
ON
Ref = 012
Laser Sensor [mm]
figure 25
figure 24