2020-08-26
GCU7 Manual
6
IV.
GAUGES OVERVIEW
RPM
RPM Gauge shows number of RPM.
GEAR POSITION SENSOR - GPS
Gear position sensor as the GCU sees it. Green field represents a gear and the range where gear is valid.
Gear ranges are only used if GCU is in “Sequential” mode. In H-Paddle Shifter mode, gear position is
calculated based on the position of the actuators & shifting direction. GPS value under the gauge is
degrees and raw value of the position sensor in the brackets.
If vehicle speed is enabled, you will find detected speed under the RPM along with the calculated rpm
based on the current gear.
THROTTLE POSITION SENSOR – TPS
0 - 100% of the throttle pedal pressed.
AIR PRESSURE
Air pressure in bar if air pressure transducer is used, otherwise only simulated number is shown
(minimum pressure from the compressor tab)
CURRENT GEAR
Gear which the gearbox is in. Total shifts is number of shifts since the last counter reset. Counter can be
reset by pressing the
RST
button next to the gear.
INPUTS & OUTPUTS
Status of each input and output. If active, it’s marked with white on red.
TESTS
By pressing one of the buttons it manually triggers the command. Please note that UP and DOWN
actuators are only available when Sequential Gearbox is used.
