2020-08-26
GCU7 Manual
28
Go to
UP
tab and:
Adjust
Allow shift from N to 1
and
R to N
accordingly.
Put these to 0:
Delay after cut
,
Keep cut after shift
,
Don’t cut if TPS <
,
Actuator preload
,
Lever
return actuator
. Increase
Delay after cut
if engine is slow to respond to the cut.
Disable:
Auto retry on failed shift
,
Autoshift
and
External cut
.
Set
Min between shifts to
200ms.
If you have MME TBC module installed (drive by wire), uncheck the
Close throttle instead of
CUT.
Under
DOWN
tab:
Adjust
Allow shift from 1 to N
and
N to R
accordingly.
Adjust the
Max engine RPM
parameter. This is the absolute maximum engine rpm you will able
to reach when downshifting.
Disable:
Allow partial shift
,
Queued downshift
and
Autoretry on failed shift
.
Enable Blip and set
Max blip duration
to 150ms. If you have MME TBC, put 30% into
Amount
and leave the custom % for each gear unchecked.
Set
Delay before activating the valve
to 10ms.
Set the
Disable blip if RPM
to 3000 and
Close blip
to 0ms. If you use MME TBC, you can also
adjust the blip % for each gear. Good value for every gear to start is 30%. Uncheck if MME TBC is
not used.
Set
Cut with blip + max cut duration
to 50 ms
Set
Blip until barrel moves (deg)
to the half travel between the gears. For example: if you have
2
nd
gear at 100 degrees and 1
st
gear at 160 degrees, total travel between the gears is 60 degrees.
Put in half of it, 30 degrees, or a little less.
Leave
Rev match
unchecked.
Set
Keep in gear after shift
to 100ms.
Set
Cut after successful shift
to 50ms.
Set
Downshift timeout
to 500ms.
Under
COMPRESSOR
tab:
Enable the Compressor.
Adjust
Start only if engine running
accordingly.
Set
Compressor control via
to External switch.
You’re all set
