MMD PowerPro Inverter Generators • IGR6000H (091615)
MMD PowerPro Inverter Generators • IGR6000H (091615)
Page 22
Page 23
The DC output is to be used to charge batteries only. Serious damage to the stator
windings can occur if connected to a DC motor or transformer.
n
The DC receptacle may be used while the AC power is in use.
n
The DC receptacle is protected from an overload with a fuse. If the DC circuit is
overloaded, the 5 amp fuse will blow and power to the DC receptacle will cease.
The red light on the DC panel will illuminate. The fuse is located to the left of the
receptacle and is accessed by snapping open the access door. Replace the fuse
with one of the same capacity. Using a higher rated fuse may cause damage to
the generator alternator.
5 AMP FUSE
ACCESS DOOR
2. Start the engine
n
The DC receptacle may be used while the AC power is in use.
n
An overloaded DC circuit will trip the DC circuit fuse. The fuse must be replaced
before the DC receptacle is operative.
n
Replace the fuse with one of the same size and rating (5A).
n
Exceeding the current rating may lead to alternator damage.
Air Conditioning Operation
n
For best results, the SMART throttle switche should be in the off position.
n
Bring the generator to normal operating temperature before applying the air
conditioning load. Always allow a 2 minute wait period when manually cycling an
air conditioner off and on.
n
A longer wait period may be required under unusually hot weather conditions.
n
Additionally, all other loads should be turned off until the air conditioner has
started and is performing normally. It is also important to follow the air conditioner
manufacturer's instructions for starting and restarting for proper operation.
n
Some air conditioner manufacturers offer a start capacitor or rapid start kit. The
lack of a start capacitor can cause the air conditioner to draw too high a starting
current and overload the generators. Contact your air conditioner manufacturer if
you consistently have problems starting your air conditioner.
n
This generator is not generally recommended for air conditioners exceeding
13,500 BTUs.
Low oil alarm system
The low oil alarm system is designed to prevent engine
damage caused by an insufficient amount of oil in
the crankcase. Before the oil level in the crankcase
falls below a safe limit, the low oil alarm system will
automatically shut down the engine (the engine switch
will remain in the ON position).
If the low oil alarm system shuts down the engine the red
low oil alarm indictor light will come on when you operate
the starter, and the engine will not run. If this occurs,
search for any oil leaks. Add engine oil to resume normal operation.
