MMD PowerPro Inverter Generators • IGR6000H (091615)
MMD PowerPro Inverter Generators • IGR6000H (091615)
Page 18
Page 19
n
14 Gauge Cords- a 14 gauge cord between 0-50 feet (0-15.2 meters) long will
adequately handle loads between 10 and 15 amps.
n
12 Gauge Cords- If your load is between 10 and 15 amps and the length of the
cord is 50-100 feet (15.2-30.5 meters), you need a 12 gauge cord to safely power
any tool.
n
The DC receptacle can be used while the AC power is in use. If both are being
used at the same time, be sure not to exceed the total power for AC and DC.
n
Most appliance motors require more than their rated wattage for start-up.
n
Keep the generator away from other electric cables or wires such as commercial
power supply lines.
AC Power Application
The generator has the capability to provide 120V and 240V AC Power. It can do
so simultaneously depending on the needs of the user. However, it is important to
understand the receptacles, their current limitations, and how to distribute power
efficiently.
VOLTAGE
SELECTION SWITCH
120V 20A GFCI
RECEPTACLE
120/240V 30A
RECEPTACLE
The GFCI (ground fault circuit interrupter) shuts off power to the protected
receptacles if a ground fault or current imbalance between two conductors is
detected. If the reset button pops out, the appliance connected to the receptacle
may be defective. If the appliance appears to be in good condition, press the reset
button until a click is heard. This will restore power. If the reset button pops out
again, disconnect all appliances disconnected immediately and have them inspected
by a qualified electrician before attempting to use them again.
n
Substantial overloading that continuously lights
the overload indicator light (red) may damage the
generator. Marginal overloading that temporarily
lights the overload indicator light (red) may shorten
the service life of the generator.
n
Be sure that all appliances are in good working order before connecting them to
the generator. If an appliance begins to operate abnormally, becomes sluggish,
or stops suddenly, turn off the generator engine switch immediately. Disconnect
the appliance and examine it for signs of malfunction.
AC operation
1. Start the engine and make sure only the output indicator light
(green) comes on.
2. Confirm that the appliance to be used is switched off, and
plug in the appliance.
n
The L14-30 receptacle is rated at 30 amps. Should the
current be exceeded, the circuit protection device will activate
and cut all current to the receptacle. This will be indicated
by the push button popping out. Reduce the load to the
receptacle and reset the circuit protector by pushing in the button.
n
Do not attempt to operate appliances if the ground fault circuit interrupter reset
button pops out repeatedly during use.
n
Only the ground fault circuit interrupter receptacle provides ground fault
protection.
Voltage Selection Switch
The voltage selection switch has two positions: AC120V and AC120/240V.
1. When the voltage selection switch is in the 120/240V position, the generator
supplies both 120V and 240V AC power. If you operate the generator with
the switch in this position, the electric current is limited to 15 amps to the
120V receptacles although it can provide 15 amps at 240V from the 120/240V
receptacle.
2. When the voltage selection switch in the 120V position, the generator supplies
120V AC only. It can supply a full 30 amps to the 30 amp receptacle or 20 amps
to the GFCI receptacle. Total current is limited to 45.8 amps at rated load.
