MLis MLB-Z4001, User Manual

Page: 27 / 33

MLB-Z4001 Terminal User Manual 27 Rev 1.0
Basic
Network Settings
DHCP Client: Enable | Disable
The user can enable this function so the IP address of this device can be obtained from DHCP Server
assignment.
The user can disable this function then the user can manually type the following static IP address
required info below accordingly.
Static IP Address: Static Subnet Mask; Static Default Gateway; Static DNS server
Connection Type: TCP | UDP
For TCP mode: Your host socket program actively connects with MLB-Z4001 which locates at the
remote site. Your MLB- Z4001 listens for the TCP connection.
For UDP mode: If you want to have real-time data transmission and your socket program uses UDP
protocol, you could set MLB-Z4001
in UDP mode. Since UDP doesn’t need to establish connection
before sending data, it can not guarantee the data will not be lost.
Transmit Timer: The timer is to control data output timeframe.
Server/Client Mode: Under TCP mode, the user can select either Server or Client mode.
For Server mode: MLB-Z4001 is configured as Static IP address and server listening port on a TCP/IP
network. So the host requests a connection from MLB-Z4001 configured for TCP Server mode. Once
the connection is established, Data can be transmitted in both directions.
For Client mode: In TCP Client Mode, MLB-Z4001 can actively establish a TCP connection with a pre-
determined host computer.
Server Listening Port: This is for the Host connecting to MLB-Z4001. The user can change the desired
port #.
Client Destination Host Name / IP: Input the host IP as the MLB-Z4001 configured for TCP Client Mode
requests a connection.
Client Destination Port: Input the host IP
’ s port as the MLB-Z4001 configured for TCP Client Mode
requests a connection.
Apply button: This is for applying the configuration setting change.
Cancel button: This is for cancelling the change of the configuration setting.
Restore default: This is for restoring back to the default setting.
Reboot: The is for rebooting the device.
Note:
1. The user needs to click on ‘ Apply ’ , and then hit ‘ Reboot ’ button to activate the change of the
settings.