Daylight sensor
WARNING
This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
GENERAL
This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities
for where facilities exist.
The batteries in this luminaire are Lithium Ion and must be disposed of correctly. Please contact the local
authorities for the disposal of this toxic waste.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the
product.
This product is non-dimmable.
WARRANTY
This product has a warranty of 5 years (excluding battery) from date of purchase. Failure to install this product in
accordance with the current edition of the IEE Wiring Regulations, improper use, or removal of the batch codes
will invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place
of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation
costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve the
right to alter product specification without prior notice.
TESTING FOR EMERGENCY LUMINAIRES
Recommended routine test procedure in accordance with BS5266
•
Daily check
–
check LED charge indicator is illuminated
•
Monthly functional test
–
simulate a mains supply failure for approx. 30 seconds by operation of key
switch or switching off circuit breaker. Ensure normal supply is restored after test and ensure charge
indicator is illuminated
•
Annual three hour duration test
–
simulate a mains supply failure for a three hour continuous test by
operation of key switch or switching off circuit breaker. Ensure normal supply is restored after test and
ensure charge indicator is illuminated
•
If the luminaire fails any of the above tests, please contact a qualified electrician
When set to
Disable,
the daylight sensor will switch the lamp on when motion is detected
regardless of the ambient light level
When set to
Disable
, the daylight sensor will
switch the lamp on when motion is detected
regardless of the ambient light level
DIP SWITCH SETTINGS
Detection area
Hold time
This is the time period the lamp remains at 100% after no motion is detected
DIP SWITCH SETTINGS
Detection area
Hold time
This is the time period the lamp remains at 100% after no motion is detected
This is the time period the lamp remains
at 100% after no motion is detected
