These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following products:
AC65136EM / AC65158EM / AC651581EM / AC65170EM / AC65236EM / AC65258EM /
AC652581EM / AC65270EM
GENERAL INSTRUCTIONS
• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)
and current Building Regulations. If in any doubt, consult a qualified electrician
• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker
• Please note the IP (Ingress Protection) rating of this luminaire/product when deciding the location for
installation
• This product is Class I and must be earthed
• This product is IP65 rated
SAFETY
INSTALLATION
• Provide power to the required point of installation
• Unfasten the clips on either side of the fitting (see Fig. 1) and remove the diffuser
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
AC65136EM / AC65158EM / AC651581EM / AC65170EM / AC65236EM / AC65258EM / AC652581EM /
AC65270EM
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire/product when deciding the location for
installation
•
This product is Class I and must be earthed
•
This product is IP65 rated
INSTALLATION
•
Provide power to the required point of installation
•
Unfasten the clips on either side of the fitting (see Fig. 1) and remove the diffuser
Fig. 1
•
Remove the gear tray from the baseplate by pinching the clips at two locations (see Fig. 2)
Fig. 2
•
Mark the location of the fixing holes and drill the holes ensuring not to infringe with any gas/water pipes
or electrical cables. Fixing centres are shown in Fig. 3
Fig. 1
