CONEX-LDS
Controller GUI Manual
4.6.1
Configuration
Factory Configuration
The “Factory” configuration contains the factory values saved in the memory of the
CONEX-LDS. This configuration is mandatory to use with Calibration verification.
Current Configuration
The “Current” configuration contains the current values defined in the selected
configuration.
Config Combo-box
The “Config” combo-box selects and applies a predefined CONEX-LDS
configuration.
Remove Button
The “Remove” button deletes the selected configuration from the list.
Remove ALL Button
The “Remove ALL” button deletes all configurations saved in the list of
configurations.
Save Button
The “Save” button saves and applies the selected configuration.
Save as Button
The “Save as” button saves and applies a user-defined CONEX-LDS configuration in
the XML configuration file. A new configuration name can be entered in the dialog
box that appears:
If the configuration name already exists, the following message pops up.
Choosing “Yes” will overwrite the current configuration and “ No “ will create and
save a new one.
Set permanent Button
Saves the new values for the range, the calibration coefficients and the offsets in the
memory of the CONEX-LDS. The controller will need to be in the Configuartion state
in order for changes to take place. The following message will pop up to verify if the
user wants to change the settings or not:
EDH0331En1032 — 12/18
18
