MKS Baratron 122B, Instruction Manual

Page: 29 / 50

Interface Cables Chapter Two: Installation
20
Interface Cables
As of January 1, 1996, most products shipped to the European Community must comply with the
EMC Directive 89/336/EEC, which covers radio frequency emissions and immunity tests. In
addition, as of January 1, 1997, some products shipped to the European Community must also
comply with the Product Safety Directive 92/59/EEC and Low Voltage Directive 73/23/EEC,
which cover general safety practices for design and workmanship. MKS products that meet these
requirements are identified by application of the CE mark.
To ensure compliance with EMC Directive 89/336/EEC, an overall metal braided shielded cable,
properly grounded at both ends, is required during use. No additional installation requirements
are necessary to ensure compliance with Directives 92/59/EEC and 73/23/EEC.
Note
1. An overall metal braided, shielded cable, properly grounded at both
ends, is required during use to meet CE specifications.
2. To order an overall metal braided shielded cable, add an “S” after the
cable type designation. For example, to order a cable to connect a 122
unit to a 146 controller, use part number CB259-5-XX, where XX
designates the cable length; for a shielded cable, part number
CB259S-5-XX.
Interface Cables
To Connect the 122B Unit to ... Use the MKS Cable ...
Standard Shielded
PDR-C-1C/2C, PDR-5B, PDR-D1 CB127-1-XX CB127S-1-XX
244, 250, 252, 260, 152 CB258-1-XX CB258S-1-XX
146, 651, 652, 186 CB259-5-XX CB259S-5-XX
XX indicates the cable length, in feet; standard length is 10 ft
Table 5: Interface Cables
Certain interface cables can be supplied by MKS, or you may choose to make your own, provided
the appropriate specifications contained herein are maintained. Refer to Figure 1 for the part
numbers for the cables used with various MKS Readout/Controller Systems.
Complete MKS Pressure Measurement System (Pressure Transducer/Power Supply/Readout)
For convenience, when you purchase a complete pressure measurement system with all MKS
components, MKS will supply (at no additional charge) the appropriate shielded cable with
connector(s), in standard nominal lengths.